Введение
If you aren't able to adjust the AM/FM channel on your radio, the tuning dial may not be working. In just a few minutes, though, you can get it replaced!
It's important not to mix this up with the volume dial, as they are unique components and will not be interchangable.
Выберете то, что вам нужно
-
-
Pull the plastic tab on the battery compartment cover panel to loosen it, then pull the panel off.
-
-
-
On the bottom of the device case's face are two T10 screws. Use a T10 Torx screwdriver to remove the two screws.
-
-
-
While using the T10 screwdriver, remove the two T10 screws on the back of the device's case.
-
-
-
-
Remove the two Phillips #00 screws located in the center of the back of the device.
-
-
-
On the bottom of the device's case there are two rubber feet. Pry the rubber feet off of the case.
-
-
-
Unplug the socket connection from the motherboard as shown in the image.
-
-
-
Remove the two 1 cm Phillips #0 screws that secure the tuning dial panel to the motherboard.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.