Запчасти

Никакие детали не требуются.

Remove the batteries from the camera to prevent danger of electric shock.
  • Remove the batteries from the camera to prevent danger of electric shock.

Добавить комментарий

Locate all five screws on the camera. Then proceed to remove all the screws.
  • Locate all five screws on the camera. Then proceed to remove all the screws.

Добавить комментарий

  • Beware, if your screwdriver does not fit properly, you may damage the screws' heads.

  • If your screwdriver does not fit, or you do not have the proper one, you can use a hot glue gun to fix the screwdriver to the head of the screw. Wait for it to harden slightly, and then try to remove the screws.

Добавить комментарий

  • Remove outer case. Pull the back away from the main body of the camera.

Добавить комментарий

  • Locate the LCD screen and anchoring screw.

  • Remove screw.

Добавить комментарий

  • Carefully pull the LCD screen away from the board it is connected to.

Добавить комментарий

  • Push both blue switches away from the holding device to unleach lcd ribbon.

  • Be careful when removing ribbon. If you damage it, you will need to replace it as well.

Добавить комментарий

  • Carefully detach the ribbon from where it was connected by the blue pins.

Добавить комментарий

  • Now that everything has been disconnected from the board, remove LCD screen.

Добавить комментарий

  • Remove the two screws holding the circuit board down.

Добавить комментарий

  • Remove black sticky tape from circuit board and camera case.

Добавить комментарий

  • Gently pull the circuit board away from the front side of the camera.

  • Be careful when removing assembly as to not break any solder leads or damage lens assembly.

Добавить комментарий

  • Remove the logic board by pulling straight away from assembly.

Добавить комментарий

  • Locate the flash unit of the camera. It includes the camera's flash and a capacitor.

Добавить комментарий

  • Unsolder the flash unit at it's three points.

  • Be careful not to damage the circuit board or surrounding parts with the solder iron.

Добавить комментарий

Заключение

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Cody

Участник с: 18.04.2010

47 Репутация

Автор 4 руководств

Команда

Cal Poly, Team 7-11, Maness Spring 2010 Member of Cal Poly, Team 7-11, Maness Spring 2010

CPSU-MANESS-S10S7G11

3 членов

Автор 4 руководств

Комментариев: 0

Добавить комментарий

Просмотр статистики:

За 24 часа: 0

За 7 дней: 1

За 30 дней: 2

За всё время: 3,626