Введение

Lots of things could cause your LCD screen to need replacing. Here's how to do it.

Запчасти

Никакие детали не требуются.

Turn the camera upside down so you can access the battery chamber.
  • Turn the camera upside down so you can access the battery chamber.

  • Make sure that the camera is powered off before opening the battery chamber. Not doing so could damage your memory card.

Добавить комментарий

Push the battery chamber latch in the direction of the front of the camera.  Keeping tension on the latch, slide the battery chamber cover toward the outside of the camera, opening the battery chamber.
  • Push the battery chamber latch in the direction of the front of the camera. Keeping tension on the latch, slide the battery chamber cover toward the outside of the camera, opening the battery chamber.

Добавить комментарий

With the battery chamber open, remove the old batteries.
  • With the battery chamber open, remove the old batteries.

  • When replacing the batteries, remember that the battery orientation is shown by the + and - marks. Each mark indicates which side of the battery faces up in the chamber.

Добавить комментарий

Remove the 4mm JIS #00 screws from the sides and bottom of the camera. Remove the 4mm JIS #00 screws from the sides and bottom of the camera. Remove the 4mm JIS #00 screws from the sides and bottom of the camera.
  • Remove the 4mm JIS #00 screws from the sides and bottom of the camera.

Добавить комментарий

Carefully pry away the rear housing cover with the plastic opening tool. Carefully pry away the rear housing cover with the plastic opening tool. Carefully pry away the rear housing cover with the plastic opening tool.
  • Carefully pry away the rear housing cover with the plastic opening tool.

Добавить комментарий

Remove the rear housing cover by carefully pulling it away from the camera.
  • Remove the rear housing cover by carefully pulling it away from the camera.

Добавить комментарий

Fold back the LCD screen with the plastic opening tool. Remove the cable coming from the LCD screen that goes into the motherboard.
  • Fold back the LCD screen with the plastic opening tool.

  • Remove the cable coming from the LCD screen that goes into the motherboard.

Добавить комментарий

Заключение

To reassemble your device, follow these instructions in reverse order.

2 участников успешно повторили данное руководство.

Joseph Kelley

Member since: 15.01.2015

228 Репутация

Автор 2 руководств

Команда

USF Tampa, Team 7-1, Remmell Winter 2015 Member of USF Tampa, Team 7-1, Remmell Winter 2015

USFT-REMMELL-W15S7G1

4 членов

Автор 5 руководств

Комментариев: 0

Добавить комментарий

Просмотр статистики:

За 24 часа: 1

За 7 дней: 1

За 30 дней: 13

За всё время: 612