Введение
The digitizer is the part that fits in front the LCD. This is records touch feedback.
Выберете то, что вам нужно
-
-
Insert the flat end of the spudger into the side of the device
-
This will create a gap between the device and screen housing.
-
Insert the plastic opening tool into this gap and move it along this gap.
-
The screen housing and device will now be separated.
-
-
-
-
Once the digitizer has been been removed from the body, disconnect the digitizer band from the motherboard.
-
Two small black pins (circled in red) will need to be unlocked.
-
Unlock the pins by pulling them outward with the tweezers.
-
Remove the band using the tweezers.
-
-
-
Once the digitizer has been disconnected from the motherboard, the LCD screen must be removed from the digitizer.
-
Push open the tabs (circled in red) using the flat end of the plastic spudger.
-
Continue to release all tabs while continuing to pry the LCD away from the digitizer.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Отменить: Я не выполнил это руководство.
Еще один человек закончил это руководство.
Команда
Montana Tech, Team 10-1, Shirk Fall 2015 Участник Montana Tech, Team 10-1, Shirk Fall 2015
MTUM-SHIRK-F15S10G1
4 членов
Автор 8 руководств
