Введение
Use this guide to replace the speaker. First you'll need to remove the rear cover. This can be a difficult process.
Выберете то, что вам нужно
-
-
Using the PH#00 screwdriver, remove the two 0.145 inch Phillips head screws.
-
-
-
Insert the plastic opening tool between the screen cover and rear cover of the tablet.
-
Grasp the small suction cup.
-
-
-
Slide the plastic opening tool along device edge to separate the screen cover from the rear cover.
-
Pull upward on the small suction cup handle while sliding the opening tool.
-
-
-
-
Using a #PH000 screwdriver, remove the three 0.145in circuit board placement screws.
-
-
-
Lift the hinge locks on the three ribbon connectors and disconnect the ribbon connectors.
-
-
-
Using a solder removal tool, remove the speaker soldered connectors.
-
Solder the new speaker wire connections to circuit board.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Отменить: Я не выполнил это руководство.
2 участников успешно повторили данное руководство.