Введение

The internal channels of your vacuum can become dirty with use. They do not need to be cleaned often, but doing so can result in quieter operation as well as less dust in the exhaust of the vacuum.

Инструменты

Запчасти

Никакие детали не требуются.

The channels that become dirty with dust are in the canister of your vacuum.
  • The channels that become dirty with dust are in the canister of your vacuum.

  • Start with the canister of your vacuum.

Добавить комментарий

Turn the canister around and locate the latch that secures the outer housing of the canister to the cyclone assembly, and push it upwards. Now, free the cyclone assembly from the clear, plastic canister housing.
  • Turn the canister around and locate the latch that secures the outer housing of the canister to the cyclone assembly, and push it upwards.

  • Now, free the cyclone assembly from the clear, plastic canister housing.

Добавить комментарий

Clean the inside of the cyclone assembly out.  Use a cloth to clean; the more dust you can clear the less dust will end up in the exhaust of your vacuum.
  • Clean the inside of the cyclone assembly out. Use a cloth to clean; the more dust you can clear the less dust will end up in the exhaust of your vacuum.

  • If you have an air compressor, don't be afraid to use it to blow the dust out of all the nooks and crannies of the cyclone assembly. This is a very sturdy component, and the strong air currents will not damage it.

Добавить комментарий

Заключение

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Donald Percivalle

Участник с: 03.10.2012

1 162 Репутация

Автор 4 руководств

Команда

Cal Poly, Team 3-22, Amido Fall 2012 Member of Cal Poly, Team 3-22, Amido Fall 2012

CPSU-AMIDO-F12S3G22

4 членов

Автор 6 руководств

Комментариев: 2

I just run the water hose through mine then let it dry completely before putting it back together and especially before using.

It's all plastic so it can't hurt anything.

Nichola - Ответить

This can be done, but can be problematic if it is not cleaned thoroughly (not just in part you can see but the cyclone chamber that is above the little holes in the graphics) the dust will turn into clay pieces which sound like rocks during operation. If not allowed to fully dry BEFORE reassembly (48 hours) the cyclone chamber will mildew resulting in a bad smell coming from the vac exhaust during operation (possibly damaging the rubber seals as a result) and since the chamber is above the little holes you can see it's difficult to resolve once it's occurred.

Wizbang FL -

Добавить комментарий

Просмотр статистики:

За 24 часа: 28

За 7 дней: 114

За 30 дней: 470

За всё время: 18,385