Введение
When playing a Nintendo Switch every button serves a specific purpose. If any of those buttons are jammed, it renders your gameplay incomplete. This can become very irritating and inconvenient, but can be quickly fixed. With a screwdriver and a pair of tweezers, your jammed button problems can be fixed. This fix will provide step by step instructions on how to quickly fix your jammed ZR and ZL buttons on your Nintendo Switch controller. These buttons are located one the right and left sides of your console on the controllers. Because they are used so often, they tend to jam and wear down over time. Excessive force when using them can cause them to jam and not come back up, thus creating our problem. In order to fix these jammed ZR and ZL buttons we’re going to following 7 simple steps.
Выберете то, что вам нужно
-
-
Using the Y00 Tri-Point screwdriver, remove four M1.4 x 5mm screws to loosen the hard plastic back of the Joy-Con.
-
-
-
After the screws are removed, lift the cover to reveal the inside of the Joy-Con and locate the ZL button.
-
-
-
Инструмент, используемый на этом этапе:Tweezers$4.99
-
Use tweezers to lift the ZL button a little then pull upwards to get it back into place.
-
Once the button is back in place, place the hard cover back on the Joy-Con and screw it back on.
-
-
-
Click the button a couple times to ensure that it's back in place and working.
-
After following those 7 steps, your gameplay should return to its original state. If the other Joy-Con also has a jammed ZL or ZR button simply repeat the 7 steps above.
Отменить: Я не выполнил это руководство.
17 человек успешно провели ремонт по этому руководству.
Команда
USF Sarasota-Manatee, Team S1-G1, Stewart Spring 2020 Участник USF Sarasota-Manatee, Team S1-G1, Stewart Spring 2020
USFSM-STEWART-S20S1G1
23 членов
Автор 33 руководств
7 Комментарии к руководству
My button problem is the actual button on the flexible circuit board. Where can I get a replacement. It simply unplugs from the main board
Hi @gregory53491, I'm not sure what button you are referring to, but here is a link to our parts store with all of the parts we currently have in stock for the Switch JoyCon. If none of the parts we have currently are what you need, you might try checking eBay for used parts. I hope this helps!
Sarah,
The button I was looking for looking for is the ZL button, and I found one on Amazon. I needed the actual on/off smd button. The one one the flexible board. When it comes in I'll give a try at writing a how-to. 👍
Hi Gregory! Thanks for the update. I'm glad you found what you needed to complete the repair :)
