Введение
This guide will show the required steps to replace the ice tray on the Insignia Ice Maker.
Инструменты
Запчасти
No parts specified.
-
-
Remove the 6 screws holding the rear casing on.
-
Remove the rear casing
-
-
-
-
-
-
-
-
Remove the plastic cover from the circuit board by pressing the lever on the side. A pry tool may be required.
-
Disconnect the water tray cord.
-
Почти готово!
To reassemble your device, follow these instructions in reverse order.
Заключение
To reassemble your device, follow these instructions in reverse order.
Один комментарий
Where do I find insignia ice maker ns- imp26ss7 replacement ice forming tray? Can't locate item on the internet.