Перейти к основному содержанию

Введение

This guide will show the required steps to replace the ice tray on the Insignia Ice Maker.

  1. Remove the 6 screws holding the rear casing on. Remove the rear casing Remove the rear casing
    • Remove the 6 screws holding the rear casing on.

    • Remove the rear casing

  2. Remove the 4 screws holding the Ice Tray to the body of the Ice Maker. Remove the 4 screws holding the Ice Tray to the body of the Ice Maker. Remove the 4 screws holding the Ice Tray to the body of the Ice Maker.
    • Remove the 4 screws holding the Ice Tray to the body of the Ice Maker.

  3. Remove the 4 screws holding the Ice Tray from the top. Remove the 4 screws holding the Ice Tray from the top. Remove the 4 screws holding the Ice Tray from the top.
    • Remove the 4 screws holding the Ice Tray from the top.

  4. Lift the Water Pump out of the way Lift the Water Pump out of the way
    • Lift the Water Pump out of the way

  5. Remove the final 2 screws. Remove the final 2 screws. Remove the final 2 screws.
    • Remove the final 2 screws.

  6. Remove the plastic cover from the circuit board by pressing the lever on the side. A pry tool may be required. Disconnect the water tray cord. Disconnect the water tray cord.
    • Remove the plastic cover from the circuit board by pressing the lever on the side. A pry tool may be required.

    • Disconnect the water tray cord.

Заключение

To reassemble your device, follow these instructions in reverse order.

Evan Taylor

Участник с: 18.01.2018

544 Репутация

Автор 5 руководств

Команда

Cal Poly, Team S21-G3, Banghart Winter 2018 Member of Cal Poly, Team S21-G3, Banghart Winter 2018

CPSU-BANGHART-W18S21G3

2 членов

Автор 5 руководств

Один комментарий

Where do I find insignia ice maker ns- imp26ss7 replacement ice forming tray? Can't locate item on the internet.

razorbllade - Ответить

Добавить комментарий

Просмотр статистики:

За 24 часа: 0

За 7 дней: 4

За 30 дней: 22

За всё время: 190