Введение

This guide give instructions on how to locate the keypad for removal and/or repair.

Запчасти

Никакие детали не требуются.

Flip over the phone and then slide down the back cover with your thumb.
  • Flip over the phone and then slide down the back cover with your thumb.

Добавить комментарий

Lever out the battery from the phone using your thumb.
  • Lever out the battery from the phone using your thumb.

Добавить комментарий

Use a plastic opening tool to pry out the two tabs on the top corners of the battery compartment. Use a plastic opening tool to pry out the two tabs on the top corners of the battery compartment.
  • Use a plastic opening tool to pry out the two tabs on the top corners of the battery compartment.

Добавить комментарий

Gently pull off hinge cap piece from the the top of the phone.
  • Gently pull off hinge cap piece from the the top of the phone.

Добавить комментарий

Using a T6 Torx Screwdriver, remove the four 7.62mm screws around the corners of the battery compartment.
  • Using a T6 Torx Screwdriver, remove the four 7.62mm screws around the corners of the battery compartment.

Добавить комментарий

Open the phone and turn it on its side. Using a plastic opening tool, run along the seam located around the sides of the phone to pop the clips holding the casing to the frame.
  • Open the phone and turn it on its side.

  • Using a plastic opening tool, run along the seam located around the sides of the phone to pop the clips holding the casing to the frame.

Добавить комментарий

Using your hand, gently pull of the back panel from the bottom half of the phone.
  • Using your hand, gently pull of the back panel from the bottom half of the phone.

Добавить комментарий

Close the phone and place it on a flat surface.
  • Close the phone and place it on a flat surface.

  • Using a plastic opening tool or your finger, lift up the motherboard from the bottom casing.

  • Be careful when pulling up the board, as there is still a ribbon cable attached to the back of the board.

Добавить комментарий

On the underside of the motherboard, find the ribbon cable that attaches the board to the rest of the phone.
  • On the underside of the motherboard, find the ribbon cable that attaches the board to the rest of the phone.

  • Using a plastic opening tool, slowly detach the ribbon cable connector, then pull the motherboard away from the frame.

Добавить комментарий

Once the motherboard is moved out of the way, pry out the keypad with a plastic opening tool
  • Once the motherboard is moved out of the way, pry out the keypad with a plastic opening tool

Добавить комментарий

Заключение

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Andrew

Участник с: 04.10.2010

358 Репутация

Автор 8 руководств

Команда

Cal Poly, Team 4-46, Amido Fall 2010 Member of Cal Poly, Team 4-46, Amido Fall 2010

CPSU-AMIDO-F10S4G46

4 членов

Автор 14 руководств

Комментариев: 0

Добавить комментарий

Просмотр статистики:

За 24 часа: 1

За 7 дней: 1

За 30 дней: 3

За всё время: 2,095