Инструменты

No tools required.

  1. Remove both 8.0 mm Phillips #1 screws, one for each wheel.
    • Remove both 8.0 mm Phillips #1 screws, one for each wheel.

  2. Remove the wheels by pulling them away from the RC car.
    • Remove the wheels by pulling them away from the RC car.

  3. Free shipping on all orders over 100 $ or containing a Pro Tech Toolkit!

    Посмотрите наш магазин
  4. Make note of where each driving gear cover is placed. They only go in one way.
    • Make note of where each driving gear cover is placed. They only go in one way.

    • Remove the eight 8.0mm Phillips #00 screws, two screws for each wheel.

  5. Pry open the two gear covers on both sides.
    • Pry open the two gear covers on both sides.

  6. Pull the driving gears off the axles by sliding them off the axles and exposing both axles.
    • Pull the driving gears off the axles by sliding them off the axles and exposing both axles.

  7. Slide both axles from the internal axles guides within the car.
    • Slide both axles from the internal axles guides within the car.

    • Reverse the steps to replace the axles.

Заключение

To reassemble your device, follow these instructions in reverse order.

Rusbell Gonzalez

Участник с: 17.09.2014

219 Репутация

Автор 5 руководств

Команда

USF Tampa, Team 1-2, Hickman Fall 2014 Member of USF Tampa, Team 1-2, Hickman Fall 2014

USFT-HICKMAN-F14S1G2

3 членов

Автор 7 руководств

Комментариев: 0

Просмотр статистики:

За 24 часа: 0

За 7 дней: 0

За 30 дней: 1

За всё время: 137