Введение
This guide will provide instructions on how to replace the LCD screen for Kodak PixPro AZ251. Replacing the LCD screen may be necessary if the screen is cracked or becomes dislodged.
Выберете то, что вам нужно
-
-
Remove a total of four 5mm JIS #000 screws from around the camera:
-
Two screws from the right side.
-
Two screws from the left side.
-
-
-
-
Open the flash module.
-
Remove the two 6mm JIS #00 screws found inside of the flash housing.
-
-
-
Use a plastic opening tool to pry apart both halves of the camera.
-
Remove the back panel.
-
-
-
Remove these three JIS #000 screws from the control board:
-
5mm screw.
-
4mm screw.
-
2mm screw.
-
-
-
Use a spudger to flip up the retaining flap on the display ribbon cable ZIF socket.
-
Pull the orange cable out of the socket.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Команда
USF Tampa, Team S1-G1, Cagle Spring 2018 Участник USF Tampa, Team S1-G1, Cagle Spring 2018
USFT-CAGLE-S18S1G1
4 членов
Автор 7 руководств
