Skip to main content

Introduction

This guide will show the steps needed to take out and replace the battery in the Lenovo Chromebook 100e 2nd gen. The only tool required for this replacement is a Philips head screwdriver.

  1. Remove the nine 6 mm screws from the back of the laptop using a Phillips #0 screwdriver.
    • Remove the nine 6 mm screws from the back of the laptop using a Phillips #0 screwdriver.

  2. Open the laptop and lay it flat. Go along the edge of the keyboard with an opening tool until it pops loose.
    • Open the laptop and lay it flat.

    • Go along the edge of the keyboard with an opening tool until it pops loose.

    • Potential for device damage: Make sure that the keyboard does not fall away from the laptop, as it is still connected to the internal components

  3. Lift the keyboard connectors up using an opening pick. Remove the connectors from their sockets.
    • Lift the keyboard connectors up using an opening pick.

    • Remove the connectors from their sockets.

  4. Remove the four 4 mm Phillips #0 screws holding the battery in.
    • Remove the four 4 mm Phillips #0 screws holding the battery in.

  5. Using an opening pick, push on the connection where the wires are connected to the motherboard.
    • Using an opening pick, push on the connection where the wires are connected to the motherboard.

    • Potential for device damage: This step takes some force to disconnect, but be careful to not pull the wires out of the battery.

  6. The battery is now loose and can be removed from the laptop.
    • The battery is now loose and can be removed from the laptop.

Conclusion

To reassemble your device, follow these instructions in reverse order.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 11

Past 30 Days: 48

All Time: 316