Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Магазин

Введение

If your Lenovo ThinkPad X1 Carbon (2nd Gen) randomly shuts off after getting hot, use this guide to replace the fan.

The fan cools down the computer and prevents the computer from overheating.

Before using this guide, check to make sure that nothing is covering the fan. The blocked fan may be the reason the computer is overheating. Also, use a dust removal spray to carefully clean out the vent. The cause of overheating may be the dust blocking the computer’s air flow. Cleaning the vent can prevent the need of replacing the fan.

Before you begin, make sure your computer is off.

  1. Using a Phillips #0 screwdriver, remove the seven  7mm screws holding the back cover onto your computer.
    • Using a Phillips #0 screwdriver, remove the seven 7mm screws holding the back cover onto your computer.

  2. Use a plastic opening tool  or your fingers to pry off the cover. Use a plastic opening tool  or your fingers to pry off the cover.
    • Use a plastic opening tool or your fingers to pry off the cover.

  3. Using your fingers, disconnect the battery from the motherboard. Using your fingers, disconnect the battery from the motherboard.
    • Using your fingers, disconnect the battery from the motherboard.

  4. The Essential Toolkit

    The most helpful tools in our most compact kit.

    Купить сейчас

    The Essential Toolkit

    The most helpful tools in our most compact kit.

    Купить сейчас
  5. Using a Phillips #0 screwdriver, unscrew the five 4.3mm screws attaching the battery to the computer.
    • Using a Phillips #0 screwdriver, unscrew the five 4.3mm screws attaching the battery to the computer.

  6. Remove the battery by pulling it directly towards you.
    • Remove the battery by pulling it directly towards you.

  7. Use a Phillips #1 screwdriver to undo the four 5 mm screws attached to the heat sink.
    • Use a Phillips #1 screwdriver to undo the four 5 mm screws attached to the heat sink.

  8. Undo the black clasp that holds the ribbon cable, attached to the fan, in place and disconnect the ribbon cable.
    • Undo the black clasp that holds the ribbon cable, attached to the fan, in place and disconnect the ribbon cable.

  9. Remove the fan by lifting it directly up.
    • Remove the fan by lifting it directly up.

Заключение

To reassemble your device, follow these instructions in reverse order.

Vanessa Garcia Sanchez

Участник с: 23.01.2020

97 Репутация

1 руководство автора

Команда

Cal Poly, Team S18-G4, White Winter 2020 Участник Cal Poly, Team S18-G4, White Winter 2020

CPSU-WHITE-W20S18G4

4 членов

Автор 7 руководств

Комментариев: 0

Добавить комментарий

Просмотр статистики:

За последние 24часов: 0

За последние 7 дней: 6

За последние 30 дней: 25

За всё время: 199