Перейти к основному содержанию
  1. Remove the three screws on the back of the device with the Phillips Screwdriver #00 bit. Using the blue opening tools or spudger, gently remove the back cover to expose the interior of the tablet.
    • Remove the three screws on the back of the device with the Phillips Screwdriver #00 bit.

    • Using the blue opening tools or spudger, gently remove the back cover to expose the interior of the tablet.

  2. Remove the six screws on the back of the motherboard with the Phillips Screwdriver #00 bit. Remove the three screws on the back of the secondary board with the Phillips Screwdriver #00 bit. Remove the ribbon cables connecting the boards to the other electrical components.
    • Remove the six screws on the back of the motherboard with the Phillips Screwdriver #00 bit.

    • Remove the three screws on the back of the secondary board with the Phillips Screwdriver #00 bit.

    • Remove the ribbon cables connecting the boards to the other electrical components.

    • Remove the ZIF connectors connecting the boards to the other electrical components.

    • Some of the ribbon cables are secured with clips, simply pry up the clips before sliding them out of the pin connectors.

  3. Disconnect the antenna module from the motherboard.
    • Disconnect the antenna module from the motherboard.

Заключение

To reassemble your device, follow these instructions in reverse order.

Mario Gjyli

Участник с: 28.09.2017

417 Репутация

Автор 3 руководств

Команда

USF Tampa, Team S2-G4, Nance Fall 2017 Участник USF Tampa, Team S2-G4, Nance Fall 2017

USFT-NANCE-F17S2G4

3 членов

Автор 12 руководств

Комментариев: 0

Добавить комментарий

Просмотр статистики:

За последние 24часов: 0

За последние 7 дней: 3

За последние 30 дней: 7

За всё время: 783