Эта версия возможно содержит некорректные исправления. Переключить на последнюю проверенную версию.
Выберете то, что вам нужно
-
Этот шаг не переведен. Помогите перевести
-
Flip over the phone so that the back is facing up.
-
Pressing your thumb against the back cover, slide the cover off of the phone.
-
-
Этот шаг не переведен. Помогите перевести
-
Use the iFixit opening tool to pry out the two tabs at the top corners of the battery compartment.
-
-
Этот шаг не переведен. Помогите перевести
-
Gently pull off the hinge cap from the top of the phone by hand.
-
-
-
Этот шаг не переведен. Помогите перевести
-
Use a T6 Torx screwdriver to remove the four 7.6 mm screws at the corners of the battery compartment.
-
-
Этот шаг не переведен. Помогите перевести
-
Open the phone and turn it on its side. You will see a seam around the Nokia’s side.
-
Use the iFixit opening tool to run along this seam to pop the clips holding the casing to the frame.
-
-
Этот шаг не переведен. Помогите перевести
-
Use your hand to gently pull off the back panel from the bottom half of the phone.
-
-
Этот шаг не переведен. Помогите перевести
-
Close the phone and place it on a flat surface.
-
Use the plastic opening tool or your finger to lift up the motherboard from the bottom casing.
-
-
Этот шаг не переведен. Помогите перевести
-
Find the underside of the motherboard and locate the ribbon cable that attaches the board to the rest of the phone. Use the plastic opening tool to slowly detach the ribbon cable connector, then pull the motherboard away from the frame.
-
-
Этот шаг не переведен. Помогите перевести
-
Pry the keypad out with the plastic opening tool once the motherboard is moved out of the way.
-
-
Этот шаг не переведен. Помогите перевести
-
Locate the small speaker module on the back of the separated battery compartment in the lower left hand corner.
-
-
Этот шаг не переведен. Помогите перевести
-
Use the plastic opening tool to pry out the microphone from the bottom of the compartment.
-