Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Магазин

Введение

This motherboard replacement guide should be attempted if other parts of the device were replaced, but the problem persisted. The steps should be followed for the Motorola G7 Play, models XT1952-3 and XT1952-2. The motherboard powers the whole device and makes it function, so it’s a very important part that should be replaced if it is damaged.

  1. Turn off your device before you begin. Use the iFixit pick to break the adhesive around the back case.
    • Turn off your device before you begin.

    • Use the iFixit pick to break the adhesive around the back case.

    • Use a heat gun, hairdryer, or iOpener to weaken the adhesive around the back case. If you're using the iOpener, please review the instructions for proper use.

  2. Detach the back case from the phone.
    • Detach the back case from the phone.

    • Make sure the back is opened right to left so the cable of the fingerprint scanner does not get damaged.

  3. Use the iFixit pick and the iFixit opening tool to pull the fingerprint scanner off of the back case. Use the iFixit pick and the iFixit opening tool to pull the fingerprint scanner off of the back case.
    • Use the iFixit pick and the iFixit opening tool to pull the fingerprint scanner off of the back case.

  4. The Essential Toolkit

    The most helpful tools in our most compact kit.

    Купить сейчас

    The Essential Toolkit

    The most helpful tools in our most compact kit.

    Купить сейчас
  5. Remove the nine 3.2mm screws from the motherboard cover with a Phillips #00 screwdriver.
    • Remove the nine 3.2mm screws from the motherboard cover with a Phillips #00 screwdriver.

  6. Lift motherboard cover off by the bottom.
    • Lift motherboard cover off by the bottom.

    • Use reverse tweezers or a similar tool if needed.

  7. Once the motherboard cover is removed, disconnect the four ribbon cables and the two wires attached to the motherboard. Once the motherboard cover is removed, disconnect the four ribbon cables and the two wires attached to the motherboard.
    • Once the motherboard cover is removed, disconnect the four ribbon cables and the two wires attached to the motherboard.

  8. Using the Phillips #00 screwdriver, remove the single 0.4 mm black screw in the center of the motherboard. Remove the motherboard from the device.
    • Using the Phillips #00 screwdriver, remove the single 0.4 mm black screw in the center of the motherboard.

    • Remove the motherboard from the device.

Заключение

To reassemble your device, follow these instructions in reverse order.

Monserath Casillas

Участник с: 10.02.2020

901 Репутация

Автор 5 руководств

Команда

Cal Poly, Team S7-G4, Regan Winter 2020 Участник Cal Poly, Team S7-G4, Regan Winter 2020

CPSU-REGAN-W20S7G4

5 членов

Автор 10 руководств

Комментариев: 0

Добавить комментарий

Просмотр статистики:

За последние 24часов: 3

За последние 7 дней: 24

За последние 30 дней: 84

За всё время: 843