Введение
If camera no longer works at all, then it might be time to replace the motherboard. Follow this guide to remove the motherboard from your camera.
Выберете то, что вам нужно
-
-
Remove the 4x3mm on the opposite side near the selector wheel.
-
Remove the 2x2mm and 3x2mm screws underneath the a/v flap.
-
-
-
Pry the back panel away from the body of the camera, using the space you just opened up.
-
A small piece of the frame of the camera may fall off, but it can be easily put back into place during reassembly.
-
-
-
-
Pry up the plastic ribbon connectors on the body of the camera to release the ribbon cables.
-
-
-
Remove the three 3x3mm screws that attach the front casing to the bottom.
-
-
-
Remove the two 3x2 screws and two 3.5x2.5 screws attaching the rear panel to the motherboard.
-
-
-
Detach the ribbon cable from the motherboard by flipping up the latch on the ribbon connector.
-
-
-
Pry up the ribbon connector that connects the ribbon cable to the lens assembly.
-
-
-
Once the lens assembly has been removed, the mother board cannot be disassembled any further.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.