Введение

If there is a power problem, you may need to reattach wires to the battery compartment or replace it completely. If the problem is Corrosion, just see the guide on corrosion.

  • In this guide we will be referring to 'left' and 'right' as though the camera's front (the part that says Nikon) is facing you.

  • Unscrew the large metal screw on the left side using a quarter and remove the battery cover.(Picture not available)

Добавить комментарий

Use a 00 Phillips head screwdriver to remove the small screw on the far left of the battery compartment.
  • Use a 00 Phillips head screwdriver to remove the small screw on the far left of the battery compartment.

Добавить комментарий

  • Pull up on the tab to remove the batteries.

  • Note: The batteries will probably fall out of their holder.

Добавить комментарий

  • Use a 00 Phillips head screwdriver to remove the four screws from inside the case.

Добавить комментарий

  • Remove the battery compartment from the camera.

  • Note: On some models, the compartment is soldered in by the wires shown. If so you will need to desolder them.

Добавить комментарий

Заключение

To reassemble your device, follow these instructions in reverse order.

2 участников успешно повторили данное руководство.

Zachary Phillips

Участник с: 08.04.2011

205 Репутация

Автор 5 руководств

Команда

Cal Poly, Team 25-26, Garner Spring 2011 Member of Cal Poly, Team 25-26, Garner Spring 2011

CPSU-GARNER-S11S25G26

3 членов

Автор 6 руководств

Один комментарий

Hey, i lost the bracket… do u guys have any idea where could i get one?

David mate - Ответить

Добавить комментарий

Просмотр статистики:

За 24 часа: 2

За 7 дней: 15

За 30 дней: 86

За всё время: 9,256