Введение

The circuit board connects all the components within the controller and provides structural support for buttons, sticks, and chips.

Запчасти

Никакие детали не требуются.

Place the controller (buttons down) on a solid surface.
  • Place the controller (buttons down) on a solid surface.

  • Remove the six 9.2mm Tri-wing Y0 screws that hold the back panel in place.

Добавить комментарий

Gently lift the back panel up, separating it from the front panel.
  • Gently lift the back panel up, separating it from the front panel.

  • Some of the buttons may fall out if they are knocked around.

Добавить комментарий

Grab the Z-button by the peg with tweezers and lift it out of the controller. During re-assembly, make sure the plastic rim and spring fit into the slot provided, or else the case will not shut.
  • Grab the Z-button by the peg with tweezers and lift it out of the controller.

  • During re-assembly, make sure the plastic rim and spring fit into the slot provided, or else the case will not shut.

Добавить комментарий

Carefully unhook the cable that is looped around the peg.
  • Carefully unhook the cable that is looped around the peg.

Um can soneone explain the peg and cable part? I dont understand it...

Tyler Goamez - Ответить

I would say that the cable is somehow "hooked" to the case and you have to get the cable away from the case so that you can pull out the board

My1 -

Lift the circuit board out of the controller.
  • Lift the circuit board out of the controller.

    • Do not grab the rumble motor to lift the circuit board as shown in the picture. It will in many cases just remove the rumble motor. Instead, grab the edges of the board.

Добавить комментарий

Заключение

To reassemble your device, follow these instructions in reverse order.

2 участников успешно повторили данное руководство.

Sean Michel

Member since: 14.01.2013

1 208 Репутация

Автор 14 руководств

Команда

Cal Poly, Team 19-44, Regan Winter 2013 Member of Cal Poly, Team 19-44, Regan Winter 2013

CPSU-REGAN-W13S19G44

4 членов

Автор 16 руководств

Комментариев: 2

this $@$* only shows how to disassemble the controller, this isnt a guide to even get the circuid board off the cable &&^&^$^ useless pieces of $@$* lmao

jmride - Ответить

Yeah this isn't very in-depth, I was hoping for a little more. I need to desolder and rewire the buttons to use for another project and I was hoping this might be a nice guide to help me do that... it's not.

Joshua Arcari - Ответить

Добавить комментарий

Просмотр статистики:

За 24 часа: 6

За 7 дней: 22

За 30 дней: 105

За всё время: 7,808