Введение

If you can't hear the other line, then your speaker is broken. Use this guide in order to replace the damaged speakerphone speaker.

Запчасти

Никакие детали не требуются.

  1. Flip the phone over to view the back.
    • Flip the phone over to view the back.

    • Remove the power and phone cords.

    Добавить комментарий

  2. Remove the seven 8mm Phillips #2 screws.
    • Remove the seven 8mm Phillips #2 screws.

    Добавить комментарий

    • Lift up the back cover slowly because there are still wires attached to the circuit board.

    • Lifting the back cover should not require a lot of force; simply lift with your fingertips.

    Добавить комментарий

  3. GIVE TOOLS. FIX FOREVER.

    GIVE TOOLS.

    FIX FOREVER.

    Spread the Fixmas cheer.

    GIVE TOOLS. FIX FOREVER.

    Spread the Fixmas cheer.

    • Disconnect the rubber piece by pulling it out of the slot, freeing the back cover completely.

    Добавить комментарий

    • Remove the six 8mm Phillips #2 screws.

    • Pull the speaker phone cover straight up.

    Добавить комментарий

    • Lift the speaker straight up.

    • The speaker may need to be slightly wiggled in order to loosen and remove.

    Добавить комментарий

    • Cut the red and white wires as close to the speaker as possible.

    • Wire cutters are preferred, but normal scissors are fine too.

    Добавить комментарий

    • Solder wires to new speaker.

    Добавить комментарий

Заключение

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Elizabeth

Участник с: 21.01.2012

160 Репутация

Автор 3 руководств

Команда

Cal Poly, Team 10-35, Amido Winter 2012 Member of Cal Poly, Team 10-35, Amido Winter 2012

CPSU-AMIDO-W12S10G35

4 членов

Автор 5 руководств

Комментариев: 0

Добавить комментарий

Просмотр статистики:

За 24 часа: 0

За 7 дней: 0

За 30 дней: 1

За всё время: 955