Введение
This bed side light is a bit tricky to open.
Purpose of this was to install an antenna jack (BNC) to attach a telescopic antenna or roof aerial.
Выберете то, что вам нужно
-
-
There is a screw under the shiny UL sticker. Remove the sticker and screw to remove this bottom panel.
-
-
-
Flipping the light upside down will present a small section of the bezel that can be pried upward. It is a small plastic strip with hooks that have to be disengaged to be removed.
-
-
-
-
We can finally unscrew two more Philips head screws to remove the button ring.
-
-
-
Now the screws holding the front screen shield need to be removed and the shield can be pulled away to the front.
-
Unscrew the four screws holding the inner screen assembly in place.
-
-
-
The inner screen assembly can be pulled out slightly to reveal tabs on each side that hold the assembly in.
-
Pry the back tabs inwards to release.
-
-
-
The screen is connected to the plastic domed back with holes. There are two screws at the back of the base of this domed panel. Remove screws to remove screen.
-
Отменить: Я не выполнил это руководство.
41 участников успешно повторили данное руководство.
13 Комментариев
Awesome teardown except for one little thing…
The factory sticker shows this is a 3530 which may not be different from a 3520. However, the bottom plate screw MUST be removed in order to separate the two halves. It is a little confusing saying “The bottom panel does not help gaining access to more screws. See next step.” I took that as being unnecessary, so skip.
I was able to fix my speaker inside it i got this alarm at a thrift store for cheap turns out the one wire just needed a better conenction to get working thank you for the steps to get to it
The first photo of step 5 is a little misleading, it looks like you are unscrewing something, it made me look for the screws
Other than that this was very helpful, thank you
