Введение

Replacing a broken or scratched lens on a Polaroid Sun 600 LMS.

  1. Move film door slide on the left side of camera forward.
    • Move film door slide on the left side of camera forward.

    • Pull film door open.

  2. Open the flash assembly by holding the sides of the top piece of the camera and pushing up gently until it snaps into place.
    • Open the flash assembly by holding the sides of the top piece of the camera and pushing up gently until it snaps into place.

    • If your camera is old or dirty, it may take more force to open the flash assembly.

    • Use a spudger on each side to separate the flash segment from the main body.

    • Be careful not to do this too hard because you may pull out the connecting wires.

    • Use several plastic opening tools around the edges of the camera's body to separate it from the plastic frame.

    • Place left hand on the gray section and right hand on the black section.

    • Pull the sections apart.

    • Carefully remove the damaged lens from the interior of the camera.

    • Replace with a new lens.

Заключение

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Ian Hosek

Участник с: 20.01.2010

345 Репутация

1 Guide authored

Команда

Cal Poly, Team 3-18, Maness Winter 2010 Member of Cal Poly, Team 3-18, Maness Winter 2010

CPSU-MANESS-W10S3G18

4 членов

Автор 4 руководств

Комментариев: 0

Просмотр статистики:

За 24 часа: 1

За 7 дней: 9

За 30 дней: 41

За всё время: 7,848