Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Магазин

Введение

How to remove the processor from the logic board.

Запчасти

Детали не указаны.

  1. Pull on outer latch. Lower door until it is level with your work surface.
    • Pull on outer latch.

    • Lower door until it is level with your work surface.

    • Before working on the computer make sure it is not plugged into a power supply, then touch a metal object. This discharges static electricity, which could damage the computer.

  2. Use the spudger to pry the clips horizontally off of the heat sink. Fully remove the clips by lifting upwards.
    • Use the spudger to pry the clips horizontally off of the heat sink.

    • Fully remove the clips by lifting upwards.

  3. Remove the heat sink by pulling upwards, off of the logic board.
    • Remove the heat sink by pulling upwards, off of the logic board.

  4. Remove the 3 screws attaching the processor to the logic board using the Phillips #2 screwdriver. Remove processor by pulling vertically upwards.
    • Remove the 3 screws attaching the processor to the logic board using the Phillips #2 screwdriver.

    • Remove processor by pulling vertically upwards.

Финишная черта

13 участников успешно повторили данное руководство.

Justin Petrilli

Участник с: 21.01.2010

2 847 Репутация

Автор 11 руководств

Команда

Cal Poly, Team 13-24, Maness Winter 2010 Участник Cal Poly, Team 13-24, Maness Winter 2010

CPSU-MANESS-W10S13G24

4 членов

Автор 20 руководств

Комментариев: 2

anyone still sell the replacement processor?

Joseph Cole - Ответить

Anyone who has upgraded their CPU’s manage to flash from MacPro1,1 to MacPro2,1? And If so How?

Michael Inman - Ответить

Добавить комментарий

Просмотр статистики:

За последние 24часов: 0

За последние 7 дней: 3

За последние 30 дней: 19

За всё время: 11,017