Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Магазин

Введение

This guide will show you how to remove the PowerLead Puto PLD003 side panel. Removing the side panel is necessary in order to replace most parts.

Запчасти

Детали не указаны.

  1. Slide the battery eject button to open the battery door.
    • Slide the battery eject button to open the battery door.

  2. With the battery door open, carefully unscrew all four 5mm Phillips #1 screws.
    • With the battery door open, carefully unscrew all four 5mm Phillips #1 screws.

  3. Place the camera so that the underside is facing up.
    • Place the camera so that the underside is facing up.

    • Remove the four 5mm Phillips #1 screws.

  4. Place the camera on a flat surface with its underside facing you.
    • Place the camera on a flat surface with its underside facing you.

    • Gently pull up on the side panel to remove it from the camera.

Заключение

To reassemble your device, follow these instructions in reverse order.

Еще один человек закончил это руководство.

Justin Tew

Участник с: 31.03.2016

767 Репутация

Автор 7 руководств

Команда

Eastern Washington University, Team 1-2, Giguere Spring 2016 Участник Eastern Washington University, Team 1-2, Giguere Spring 2016

EWU-GIGUERE-S16S1G2

4 членов

Автор 7 руководств

Комментариев: 0

Добавить комментарий

Просмотр статистики:

За последние 24часов: 0

За последние 7 дней: 0

За последние 30 дней: 0

За всё время: 79