Введение

Step-by-step guide to removing your phone's back plate.

Запчасти

Никакие детали не требуются.

Flip phone to see back cover. Using either finger or spugder tool press button located  near the top of phone by the antenna.
  • Flip phone to see back cover.

  • Using either finger or spugder tool press button located near the top of phone by the antenna.

Добавить комментарий

Pry up back plate from phone to reveal battery. Push button near bottom of battery using either your finger of the spudger.  This will release the battery.
  • Pry up back plate from phone to reveal battery.

  • Push button near bottom of battery using either your finger of the spudger. This will release the battery.

Добавить комментарий

Using a T6 Torx Screwdriver remove the four torxs on the back of the phone.
  • Using a T6 Torx Screwdriver remove the four torxs on the back of the phone.

Добавить комментарий

Simultaneously press indicated buttons on both sides of phone. Simultaneously press indicated buttons on both sides of phone.
  • Simultaneously press indicated buttons on both sides of phone.

Добавить комментарий

Separate back plate from the rest of phone.
  • Separate back plate from the rest of phone.

  • Make sure to not pull, there is a wire (circled on image) connecting the two plates.

Добавить комментарий

Заключение

To reassemble your device, follow these instructions in reverse order.

Elizabeth OBrien

Участник с: 26.04.2010

31 Репутация

Автор 14 руководств

Команда

Cal Poly, Team 30-40, Garner Spring 2010 Member of Cal Poly, Team 30-40, Garner Spring 2010

CPSU-GARNER-S10S30G40

4 членов

Автор 14 руководств

Комментариев: 0

Добавить комментарий

Просмотр статистики:

За 24 часа: 0

За 7 дней: 0

За 30 дней: 6

За всё время: 3,144