Введение

Use this guide to replace the LCD.

Запчасти

Никакие детали не требуются.

  1. Okay, so here is Nikon Coolpix L20 purchased for $8.00. Only issue identified is an obviously cracked LCD screen
    • Okay, so here is Nikon Coolpix L20 purchased for $8.00. Only issue identified is an obviously cracked LCD screen

    Добавить комментарий

  2. Open the USB cover
    • Open the USB cover

    • Remove the two Phillips screws on this side.

    • Remove the one Phillips screw the left side

    • Remove the three Phillips screws on the bottom

    Добавить комментарий

  3. Free shipping on orders over $20
    Use code BLUEANDBLACK at checkout
    Free shipping on orders over $20
    Use code BLUEANDBLACK
    • Open the battery cover.

    • Separate the rear cover from the front by simply gently pulling the two halves apart. You may have to use your fingernails to separate them. Start at the bottom side, by the AC Power cover. Work your way around the bottom.

    • Once the bottom part of the halves is released, gently pull the back cover in an upward motion. The top is secured by some tabs to the front part.

    Добавить комментарий

    • With the halves separated, you are now looking at the LCD in the bracket unit.

    • gently fold the LCD toward the ribbon cable out of the bracket unit. DO NOT try to remove the LCD or to loosen the cable.

    • Remove the four screws from the bracket unit.

    Добавить комментарий

    • When you remove this screw, make sure that the shield plate on top of the bracket plate, is just slightly pushed out of the way. This will free the bracket plate.

    • After the removal of the bracket plate, you have access to the connector. Move the white clip gently to the lift (upright) position, to free the cable.

    • The LCD should now easily separate from the logic board.

    Добавить комментарий

    • For the reassembly, the trickiest part is to bend the LCD ribbon cable so that it fold under the LCD into the bracket unit.

    • Use caution and patience so as to not cut the cable on the bracket unit.

    • After reassembly, you should hopefully have the same result as I did. Total cost $8.00 for the camera, $15.00 for the LCD and one hour of my time...

    Добавить комментарий

Заключение

To reassemble your device, follow these instructions in reverse order.

4 участников успешно повторили данное руководство.

oldturkey03

Участник с: 29.09.2010

543 782 Репутация

Автор 101 руководств

Команда

OTS Member of OTS

Business

1 член

Автор 122 руководств

Один комментарий

Very good, I really appreciate it. Thank you.

Linda Musnuff - Ответить

Добавить комментарий

Просмотр статистики:

За 24 часа: 1

За 7 дней: 8

За 30 дней: 18

За всё время: 5,822