Перейти к основному содержанию

SOMNOcomfort and SOMNObalance Ventilator Filter Replacement

Медицинское оборудование
Ни iFixit, ни данное руководство по ремонту не одобрены и не связаны с производителем медицинского оборудования.
  1. SOMNOcomfort and SOMNObalance Ventilator Filter Replacement, Filter: шаг 1, изображение 1 из 1
    • Locate the Filter Compartment on the back of the ventilator.

  2. SOMNOcomfort and SOMNObalance Ventilator Filter Replacement: шаг 2, изображение 1 из 1
    • Push the compartment cover (22) up (from the bottom)

  3. SOMNOcomfort and SOMNObalance Ventilator Filter Replacement: шаг 3, изображение 1 из 1
    • Remove the coarse dust filter(68)

  4. SOMNOcomfort and SOMNObalance Ventilator Filter Replacement: шаг 4, изображение 1 из 1
    • Remove the fine dust filter(67)

    • Replace the filters and close the cover on the rear of the unit.

  5. SOMNOcomfort and SOMNObalance Ventilator Filter Replacement: шаг 6, изображение 1 из 1
    • Reset the filter change indicator by pressing and holding the on/off switch(19) until the filter change indicator goes blank.

    • If the fine filter was changed due to soiling before 250 operating hours, the hours meter must be reset to zero. Proceed as follows:

    • When switching the unit on, press and hold the on/off switch 19. The filter change indicator will come on after about three seconds before going off again after another three seconds. Release the on and off switch.

Заключение

To reassemble your device, follow these instructions in reverse order.

Diya Jamwal

Участник с: 11/07/18

553 Репутация

Автор 3 руководств

Команда

Cal Poly, Team S1-G3, Zimmerman Spring 2020 Участник Cal Poly, Team S1-G3, Zimmerman Spring 2020

CPSU-ZIMMERMAN-S20S1G3

5 членов

Автор 10 руководств

0 Комментариев

Добавить комментарий

Просмотр статистики:

За последние 24часов: 0

За последние 7 дней: 5

За последние 30 дней: 9

За всё время: 124