Введение
Use this guide to replace a faulty Vibration Motor.
Выберете то, что вам нужно
-
-
Insert plastic opening tool under back cover.
-
Apply pressure on tool while using a downward motion to pop off back cover.
-
-
-
Insert plastic opening tool under back cover.
-
Pry the top cover upward to remove it from the phone.
-
-
-
-
Remove the four 3.8mm Phillips #000 screws securing the top cover to the back assembly.
-
-
-
Insert plastic opening tool under top cover.
-
Using hand slide top cover away from phone.
-
-
-
Remove the four 3.8mm Phillips #000 screws securing the back assembly to the phone.
-
-
-
Insert plastic opening tool between back assembly and phone.
-
Pry the back assembly away from phone.
-
-
-
Insert the pointed end of a spudger into the gap in the round housing frame.
-
Using spudger to remove vibrator remove from the adhesive.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Отменить: Я не выполнил это руководство.
Еще один человек закончил это руководство.