Введение

Use this guide to replace the rear-facing camera assembly in your Samsung Galaxy Note II.

  1. Grasp the end of the stylus and remove it from its slot in the midframe.
    • Grasp the end of the stylus and remove it from its slot in the midframe.

  2. Pry with a plastic opening tool, or your fingernail, in the divot to the left of the rear-facing camera, near the power button.
    • Pry with a plastic opening tool, or your fingernail, in the divot to the left of the rear-facing camera, near the power button.

    • Lift the rear case by the corner nearest the divot and remove it from the phone.

    • If you have an SD card inserted, use the flat end of a spudger, or your fingernail, to press the microSD card slightly deeper into its slot until you hear a click.

    • After the click, release the card and it will pop out of its slot.

    • Remove the microSD card.

    • For reassembly, push the microSD card into the slot until it clicks in place.

    • Insert a plastic opening tool, or your finger, into the notch of the battery compartment and lift the battery upward.

    • Remove the battery from the midframe.

    • Remove the eleven 4.0 mm Phillips #00 screws securing the midframe to the display assembly.

    • Insert your plastic opening tool between the midframe and front panel assembly on the side of the phone.

    • Slide the plastic opening tool down the seam.

    • Continue to run the plastic opening tool down the seam.

    • Carefully pry around the corner with a plastic opening tool.

    • Pry along the top of the phone with a plastic opening tool.

    • Push the plastic opening tool down to free the corner of the midframe from the display assembly.

    • Free the clips along the power button side of the phone.

    • Lastly, free the two clips along the top and bottom edge of battery compartment.

    • Lift the display assembly out of the midframe.

    • Use a spudger to disconnect the vibrator/power button assembly cable connector.

    • Disconnect the antenna cable connector.

    • Disconnect the display cable connector.

    • Disconnect the front-facing camera cable connector.

    • Disconnect the headphone jack cable connector.

    • Disconnect the digitizer cable connector.

    • Use the spudger to disconnect the antenna cable connector from the motherboard.

    • Disconnect the soft button cable connector.

    • Disconnect the USB board cable connector.

    • Remove the 3 mm Phillips #00 screw securing the motherboard to the display assembly.

    • Gently remove the motherboard.

    • Hold the motherboard by its edges to prevent ESD damage. Be careful not to snag it on any cables as you extract it from the display assembly.

    • Use a spudger to disconnect the rear-facing camera assembly cable connector.

    • Use tweezers, or your fingers, to remove the rear-facing camera assembly.

Заключение

To reassemble your device, follow these instructions in reverse order.

13 участников успешно повторили данное руководство.

Sam Lionheart

Участник с: 18.10.2012

350 879 Репутация

Автор 535 руководств

Команда

iFixit Member of iFixit

Community

108 членов

Автор 7 544 руководств

Комментариев: 0

Просмотр статистики:

За 24 часа: 0

За 7 дней: 4

За 30 дней: 31

За всё время: 11,364