Введение

This guide will show you how to take apart the fan to remove the Printed Circuit Board.

Запчасти

Никакие детали не требуются.

Use a Philips #2 screwdriver to unscrew the four 6mm Phillips #0 back screws.
  • Use a Philips #2 screwdriver to unscrew the four 6mm Phillips #0 back screws.

  • Do this by unscrewing from left-to-right then pull the screws out of the back of the fan

Добавить комментарий

Pull the front and back cover apart.
  • Pull the front and back cover apart.

  • Be careful not to pull the front cover off completely because it holds the wires.

Добавить комментарий

  • Remove the Phillips (5-mm head) 6-mm screw that holds the circuit board to the outer shell of the fan.

  • Make sure the fan is unplugged while removing the circuit board as you may get shocked.

  • To remove the screws, unscrew in a left-to-right fashion at an angle to make sure that the wires do not get tangled.

Добавить комментарий

  • Remove the top cover containing the circuit board and the wires by pulling it away from the body of the fan.

Добавить комментарий

  • Remove the circuit board from the top cover. Do not touch the other side of the circuit board as you may damage circuit elements.

  • Unscrew the four screws on the top of the circuit board in a left-to-right fashion. After pull screws out of the board.

Добавить комментарий

Заключение

To reassemble your device, follow these instructions in reverse order.

Mateo Begue

Участник с: 26.09.2012

78 Репутация

Автор 2 руководств

Команда

Cal Poly, Team 15-46, Forte Fall 2012 Member of Cal Poly, Team 15-46, Forte Fall 2012

CPSU-FORTE-F12S15G46

5 членов

Автор 6 руководств

Комментариев: 0

Добавить комментарий

Просмотр статистики:

За 24 часа: 0

За 7 дней: 0

За 30 дней: 3

За всё время: 875