Введение

Screens for cellular devices are prone to cracking or shattering. There are several prerequisite steps required to access and remove the screen in place in your device. This guide will show you how to access the screen in order to replace in.

Запчасти

Никакие детали не требуются.

  1. Begin the disassembly by placing your Sony Ericsson QuickShare T630 on a flat surface.
    • Begin the disassembly by placing your Sony Ericsson QuickShare T630 on a flat surface.

    Добавить комментарий

  2. Slide the protective panel on the backside of the phone downward and remove it entirely, revealing the battery underneath.
    • Slide the protective panel on the backside of the phone downward and remove it entirely, revealing the battery underneath.

    Добавить комментарий

    • Slide the battery upward to remove.

    Добавить комментарий

    • Remove the rubber plug located near the camera by gently prying upward with your fingers.

    • Gently lift the camera shield after removal of the rubber plug.

    Добавить комментарий

  3. Spread Fixmas Cheer
    Получите $12 за покупку от $50 и выше с промокодом FIXMAS12
    Spread Fixmas Cheer
    Получите $12 за покупку от $50 и выше с промокодом FIXMAS12
    • Pry the remaining panel to loosen its contact to the phone using a spudger.

    • Slide the panel upward to remove it completely.

    • These steps will require a slight appliance of force.

    Добавить комментарий

    • Slide the aerial upward to remove it.

    Добавить комментарий

    • Locate screws on four corners of device

    • Remove the screws

    Добавить комментарий

    • Gently lift and remove the front panel of the phone after removing the screws.

    Добавить комментарий

    • This step is NOT required for joystick maintenance or keypad maintenance and replacement! Continue on to step 10 if you are attempting to achieve either of these goals.

    • Slowly lift the screen to reveal the green circuit ribbon connecting the screen to the phone.

    • Gently pull the ribbon from the circuit/

    • Remove the now disconnected screen.

    Добавить комментарий

    • Remove the keyboard by slowly pulling it away from the circuit board.

      • There are no direct connections between the keyboard and phone.

      • These are all of the parts covered in this disassembly that make up the Sony Ericsson QuickShare T630.

    Добавить комментарий

  4. Добавить комментарий

Заключение

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Jeremy

Участник с: 16.10.2013

156 Репутация

1 Guide authored

Команда

University of Maine, Team 1-1, Diaz Fall 2013 Member of University of Maine, Team 1-1, Diaz Fall 2013

UMAINE-DIAZ-F13S1G1

4 членов

Автор 6 руководств

Один комментарий

Worked well until the screen replacemet - ribbon cable would not go into clamp - phone plus new screen straight in the bin - a little gutted - but hey it was an old but loved phone.

roger hiley - Ответить

Добавить комментарий

Просмотр статистики:

За 24 часа: 1

За 7 дней: 3

За 30 дней: 5

За всё время: 1,005