Запчасти

Никакие детали не требуются.

Tools you will need is the Phillips #00 precision screwdriver, Plastic Opening Tools, and tweezers. Insert plastic opening tool in the corner of device and slide along edges to separate adhesive Remove cover
  • Tools you will need is the Phillips #00 precision screwdriver, Plastic Opening Tools, and tweezers.

  • Insert plastic opening tool in the corner of device and slide along edges to separate adhesive

  • Remove cover

Добавить комментарий

Locate the SD card reader in the bottom left hand corner
  • Locate the SD card reader in the bottom left hand corner

  • Remove all screws connecting the metal plate to the device.

Добавить комментарий

After all the screws have been removed lift the circuit board up to wiggle free.
  • After all the screws have been removed lift the circuit board up to wiggle free.

Добавить комментарий

After Wiggled free place the tweezers on the piece of electrical tape connecting it to the device.
  • After Wiggled free place the tweezers on the piece of electrical tape connecting it to the device.

  • Once placed there lift up and disconnect the SD card reader from the device.

Добавить комментарий

Заключение

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Martin Luna

Участник с: 24.09.2014

1 504 Репутация

Автор 5 руководств

Команда

USF Tampa, Team 15-6, Remmell Fall 2014 Member of USF Tampa, Team 15-6, Remmell Fall 2014

USFT-REMMELL-F14S15G6

3 членов

Автор 5 руководств

Комментариев: 0

Добавить комментарий

Просмотр статистики:

За 24 часа: 0

За 7 дней: 11

За 30 дней: 24

За всё время: 1,387