Trio STEALTH-9 Speaker Replacement

Введение

Here, you will be taking apart your device so that you will have access to the speaker on your Trio. For the following steps, you must be very careful with some of the wires because of how thin they are, and you will be using soldering tools for this process as well.

Выберете то, что вам нужно

Шаг 1 Back Cover

Trio STEALTH-9 Speaker Replacement, Back Cover: шаг 1, изображение 1 из 1

Remove the two Phillips #00 screws on the side of the tablet.

Редактировать

Шаг 2

Take one of the plastic opening tools and wedge it in the middle of the tablet, starting on the USB Port side.
Holding the tool in place, take one of the 6 plastic opening picks and slide it across the opening you made with the opening tool.

Редактировать

Шаг 3

Continue going around the tablet sides with the plastic pick, being sure that you are maintaining the openings you made with either your hand or the opening tool.
You will notice some popping as you go around with the pick. Don't worry, this is completely normal.

Редактировать

Шаг 4

Remove the back cover of the tablet to reveal the internals.
To replace, pinch each of the ends together until all four sides are closed.

Редактировать

Шаг 5 Speaker

Trio STEALTH-9 Speaker Replacement, Speaker: шаг 5, изображение 1 из 1

Slowly remove the electrical tape holding down the Speaker wires.

Редактировать

Шаг 6

Remove the #00 screw on the Speaker mount and remove the Speaker mount.

Редактировать

Шаг 7

Prepare your Soldering tools. Desolder the Speaker leads from the Motherboard.
Remove any excess solder as necessary, and apply new solder when replacing a Speaker.

Редактировать