Инструменты

Запчасти

Никакие детали не требуются.

  1. Place the hydraulic floor jack under the vehicle until the saddle is directly under the crossmember. The crossmember is the long metal support beam that runs underneath from the front fender to the rear fender on both sides of the car.
    • Place the hydraulic floor jack under the vehicle until the saddle is directly under the crossmember.

    • The crossmember is the long metal support beam that runs underneath from the front fender to the rear fender on both sides of the car.

    • The saddle is the round metal part of the jack that moves upward as you pump the jack up.

  2. Push downward on the jack's lever to lift the saddle upward so that it contacts the crossmember. Continue pushing downward on the lever to lift the car upward.
    • Push downward on the jack's lever to lift the saddle upward so that it contacts the crossmember. Continue pushing downward on the lever to lift the car upward.

  3. Free shipping on all orders over 100 $ or containing a Pro Tech Toolkit!

    Посмотрите наш магазин
  4. Place the jack stand under the jack mounting point.
    • Place the jack stand under the jack mounting point.

    • The jack mounting point is a metallic protrusion beneath each of the car doors.

  5. Raise the jack stand until it contacts the jack mounting point.
    • Raise the jack stand until it contacts the jack mounting point.

    • In the event the floor jack fails, the jack stand is designed to prevent the car from falling.

Заключение

To reassemble your device, follow these instructions in reverse order.

4 участников успешно повторили данное руководство.

Shaun MacDonald

Участник с: 03.10.2012

1 947 Репутация

Автор 8 руководств

Команда

Cal Poly, Team 24-27, Regan Fall 2012 Member of Cal Poly, Team 24-27, Regan Fall 2012

CPSU-REGAN-F12S24G27

4 членов

Автор 17 руководств

Комментариев: 0

Добавить комментарий

Просмотр статистики:

За 24 часа: 23

За 7 дней: 168

За 30 дней: 587

За всё время: 20,246