Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Запчасти и инструменты

Запчасти

Детали не указаны.

  1. Open SIM card flap and remove SIM card. Use a pair of tweezers to get the SIM card out.
    • Open SIM card flap and remove SIM card. Use a pair of tweezers to get the SIM card out.

  2. Use a guitar pick to open the cover of the tablet. For most effective results, start at the corner of the tablet and continue.
    • Use a guitar pick to open the cover of the tablet. For most effective results, start at the corner of the tablet and continue.

    • **BE SURE NOT TO DAMAGE THE SIM CARD OR SD CARD SLOTS**

  3. Manta Driver Kit

    112 bits for every fix.

    Upgrade Your Toolbox

    Manta Driver Kit

    Upgrade Your Toolbox
  4. Continue opening the cover now using a metal spudger and wiggle it to pry the cover open. You can look at the picture of the rear cover to see where the snaps are located.
    • Continue opening the cover now using a metal spudger and wiggle it to pry the cover open.

    • You can look at the picture of the rear cover to see where the snaps are located.

  5. Remove the screws attached to the circuit board on the battery using a Phillips 00 screw head and remove  the battery.
    • Remove the screws attached to the circuit board on the battery using a Phillips 00 screw head and remove the battery.

    • There was no adhesive on the back of the battery, just along the sides.

  6. Be careful when removing the ribbon cables as there is adhesive on the back of them. To remove the cables flip up the rear part of the connector to slide the cable out - *gently*. The USB Charging Connector and the Antenna Board both have adhesive on the back. Remove the screws and carefully lift up on the boards to remove them. **Be careful with the antenna cable!**
    • Be careful when removing the ribbon cables as there is adhesive on the back of them. To remove the cables flip up the rear part of the connector to slide the cable out - *gently*.

    • The USB Charging Connector and the Antenna Board both have adhesive on the back. Remove the screws and carefully lift up on the boards to remove them.

    • **Be careful with the antenna cable!**

  7. Remove the 5 screws holding the Mainboard and Speakers in to place. *One of the screws is under the ribbon cable*
    • Remove the 5 screws holding the Mainboard and Speakers in to place. *One of the screws is under the ribbon cable*

    • There was no adhesive holding this board in and the whole assembly lifted out as one piece.

Заключение

To reassemble your device, follow these instructions in reverse order.

26 участников успешно повторили данное руководство.

SMcC21985

Участник с: 10.11.2015

1 093 Репутация

Автор 2 руководств

Комментариев: 2

what size screws are thoze i need to get some i lost some

stacy - Ответить

Добавить комментарий

Просмотр статистики:

За последние 24часов: 8

За последние 7 дней: 41

За последние 30 дней: 182

За всё время: 15,149