Введение

This guide will demonstrate how to replace the back cover of the Balance Board.

Flip device upside-down so the plastic white board is facing the ground.
  • Flip device upside-down so the plastic white board is facing the ground.

  • Locate the four feet in the corners of the Balance Board.

  • Unscrew the three 12.7 mm Philips screws from each foot cover.

Добавить комментарий

Remove the grey plastic ring from the actual foot by lifting it up.
  • Remove the grey plastic ring from the actual foot by lifting it up.

Добавить комментарий

Mac RAM Kits
Speed up your Mac. Max out its memory.
Mac RAM Kits
Get more memory out of your Mac.
Separate the loose foot from the device by lifting it up.
  • Separate the loose foot from the device by lifting it up.

Добавить комментарий

Repeat steps two and three on the remaining four feet.
  • Repeat steps two and three on the remaining four feet.

Добавить комментарий

Unscrew the ten 12.7 mm #1 screws.
  • Unscrew the ten 12.7 mm #1 screws.

Добавить комментарий

Lift off the gray back cover.
  • Lift off the gray back cover.

Добавить комментарий

Заключение

To reassemble your device, follow these instructions in reverse order.

Cory Olson

Member since: 29.09.2014

675 Репутация

Автор 4 руководств

Команда

Cal Poly, Team 13-8, Forte Fall 2014 Member of Cal Poly, Team 13-8, Forte Fall 2014

CPSU-FORTE-F14S13G8

5 членов

Автор 5 руководств

Комментариев: 0

Добавить комментарий

Просмотр статистики:

За 24 часа: 0

За 7 дней: 1

За 30 дней: 7

За всё время: 284