Выберете то, что вам нужно
-
-
Remove the seven 12mm JIS #00 screws that hold the back panel in place.
-
-
-
Lift up on the back panel of the ZD-N Plus to remove it from the rest of the controller.
-
-
-
-
Remove the electrical connector attaching each rumble motor to the controller.
-
Lift up on the circular section of the rumble to remove it from the controller.
-
-
-
Remove the three 1.2mm JIS #00 screws that hold the motherboard in place.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Отменить: Я не выполнил это руководство.
Еще один человек закончил это руководство.