Перейти к основному содержанию

Изменения для iPad 2 Wi-Fi EMC 2415 Front Panel Adhesive Strips Replacement Введения

Редактировать с помощью Andrew Optimus Goldheart -

Правка одобрена автор Andrew Optimus Goldheart

До
После
Без изменений
Introduction
Replace the adhesive securing the front panel to the rear case of your iPad 2 Wi-Fi.
Before you begin peeling and sticking tape, it's important to have clean adhesion surfaces on both the front panel and the rear case. Use a spudger to scrape off any large excess bits of original adhesive, then clean all of the gluing surfaces with a paper towel and rubbing alcohol or Goof Off.
Throughout this procedure, it is recommended to peel up each adhesive strip as needed.