Перейти к основному содержанию

Изменения для Black and Decker LDX 120C Safety switch and trigger chip Replacement Введения

Редактировать с помощью Harmeet Dhaliwal -

Правка одобрена автор Harmeet Dhaliwal

До
После
Без изменений
Introduction
Guide to replacing aOne of the reasons you would replace the safety switch is if it does not alternate between the on and off position. The switch could be stuck or jammed safety switch or trigger chip.jammed, If this is the case then we would need to replace it. Some of the tools needed to repair this will be a soldering iron and soldering flux. In order to complete this repairrepair, some soldering skills will be required.
Guide to replacing aOne of the reasons you would replace the safety switch is if it does not alternate between the on and off position. The switch could be stuck or jammed safety switch or trigger chip.jammed, If this is the case then we would need to replace it. Some of the tools needed to repair this will be a soldering iron and soldering flux. In order to complete this repairrepair, some soldering skills will be required.