Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Магазин

Изменения для MacBook Air 13" Mid 2012: loose or rattling trackpad repair Введения

Редактировать с помощью Marc Malkwitz -

Правка одобрена автор Marc Malkwitz

До
После
Без изменений
Introduction
In some MacBook Air and presumably many other MacBooks with similar trackpads, these tend to become loose or rattle. It is a often read mistake, that this can be adjusted or "repaired" by the central adjustment screw of the trackpad, which will only make it worse. The reason for the loose trackpad however can be found in the failure of two tiny buffers, that work as upper stop of the trackpad. Tiny as they are, no one seems to know them and unsurprisingly they fail after thousands or even millions of workcycles. [ … ] In rest position, they press the trackpad against the contact point of the mentioned adjustment screw and the click button. When you click, they decompress and when you release, they are recompressed by the bounce of the click button, which explains why their elastic force must be rather small. [ … ] Steps 1-11 base on older guides, which contain the some wrong information: '''Do not follow step 10!''' The mentioned screw is only for adjustment of the clickpoint and must not be unscrewed. The trackpad already comes out after Step 8 [ … ] In this working position, we act directly above the display. So better place a thick cloth or any other protective material between screen an lower case before you begin.
In some MacBook Air and presumably many other MacBooks with similar trackpads, these tend to become loose or rattle. It is a often read mistake, that this can be adjusted or "repaired" by the central adjustment screw of the trackpad, which will only make it worse. The reason for the loose trackpad however can be found in the failure of two tiny buffers, that work as upper stop of the trackpad. Tiny as they are, no one seems to know them and unsurprisingly they fail after thousands or even millions of workcycles. [ … ] In rest position, they press the trackpad against the contact point of the mentioned adjustment screw and the click button. When you click, they decompress and when you release, they are recompressed by the bounce of the click button, which explains why their elastic force must be rather small. [ … ] Steps 1-11 base on older guides, which contain the some wrong information: '''Do not follow step 10!''' The mentioned screw is only for adjustment of the clickpoint and must not be unscrewed. The trackpad already comes out after Step 8 [ … ] In this working position, we act directly above the display. So better place a thick cloth or any other protective material between screen an lower case before you begin.

Шаги

Step #: 1
До
После
Step #: 2
До
После
Step #: 3
До
После
Step #: 4
До
После
Step #: 5
До
После