Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Магазин

Возврат к шагу #2

Редактировать с помощью 101 Tech USA -

Правка одобрена автор 101 Tech USA

До
После
Без изменений

Шаг Линий

[* black] Put the wire harness back in place by sliding the lower portion down into the slot in the gearbox, then pushing the top end back down. There is a round hole in the harness that corresponds to a small peg in the gearbox. Don't forget to hook the trigger plunger spring back onto its post.
[* blackgreen] Reinstall the small screw that holds the wire harness in place.
[* blackyellow] Make sure the trigger spring is attached to the trigger as shown.
[* blackgreen] Reinstall the small screw that holds the wire harness in place.
[* blackyellow] Make sure the trigger spring is attached to the trigger as shown.

Изображение 2

Старая версия

Новая версия

Изображение 3

Старая версия

Новая версия