Возврат к шагу #3
Отредактированно Jeff Suovanen -
Правка одобрена автор Jeff Suovanen
- До
- После
- Без изменений
Шаг Линий
| - | [* black] |
|---|---|
| + | [* black] Secure a suction cup to the back cover, as close to the heated edge as possible. |
| [* icon_note] The suction cup will not make a good seal on the curved portion of the glass, so avoid putting it on the very edge. | |
| - | [* black] Lift on the suction cup, and insert a Halberd spudger or opening pick under the rear glass. |
| - | [* icon_note] Due to the curved glass, you will be pushing up, rather than inserting parallel to the plane of the phone. |
| + | [* black] Lift the back cover's left edge with your suction cup, and insert a thin pry tool under the back cover. |
| + | [* icon_note] This may require a significant amount of force, but you only need to open a very slight gap with the suction cup to insert your tool. |
| + | [* icon_note] If you have trouble, apply more heat to further soften the adhesive, and try again. |