Возврат к шагу #2
Редактировать с помощью Adam O'Camb -
Правка одобрена автор Adam O'Camb
- До
- После
- Без изменений
Шаг Линий
[* black] When the back panel is warm to the touch, apply a suction cup as close to the heated edge of the phone as you can while avoiding the curved edge. |
[* icon_note] The suction cup will not make a good seal on the curved portion of the glass. |
[* icon_note] If the phone's back cover is cracked, the suction cup may not stick. [https://d3nevzfk7ii3be.cloudfront.net/igi/4MmKE22Cy2MavVZU|Try lifting it with strong tape|new_window=true], or superglue the suction cup in place and allow it to cure so you can proceed. |
[* black] Lift on the suction cup and insert an opening pick under the rear glass. |
[* icon_note] Due to the curved glass, you will be pushing up, rather than inserting parallel to the plane of the phone. |
[* icon_note] If you have trouble, apply more heat to further soften the adhesive, and try again. The adhesive cools very fast, so you may need to heat it repeatedly. |