Перейти к основному содержанию

Отремонтируйте ваше устройство

Обучение ремонту

Запчасти и инструменты

Возврат к шагу #3

Редактировать с помощью Eric Janson -

Правка отклонена автор Ryan Lutz

Без изменений

Шаг Линий

[* black] Allow the lower EMI shield to hang down from the display.
[* red] Remove the four 7.5 mm T10 Torx screws securing the display to the rear case.
[* icon_note] The screws are recessed, so a thin magnetic screwdriver aids in removal. Most bit drivers are too short to reach these screws.
[* black] When reassembling (if you don't have a magnetic screwdriver) something sticky on the end of your screwdriver (like a small amount of toothpaste) helps to hold the screws on until they're in place.