Перейти к основному содержанию

Изменения к шагу №5

Отредактированно Dominik Schnabelrauch -

Правка одобрена автор Dominik Schnabelrauch

Удален
Добавлено
Без изменений

Шаг Линий

[* black] Once the screen is warm to the touch, apply a suction cup to the lower edge of the phone.
[* black] If the phone's screen is cracked, the suction cup may not stick. Try [https://d3nevzfk7ii3be.cloudfront.net/igi/4MmKE22Cy2MavVZU|lifting it with strong tape|new_window=true], or superglue the suction cup in place and allow it to cure so you can proceed.
[* black] Lift on the suction cup, and insert a halberd spudger under the display assembly.
[* icon_note] Due to the curved glass, you will be pushing up, rather than inserting parallel to the plane of the phone.
[* black] Start to slide the halberd spudger along the lower edge of the phonephone to cut the adhesive. Leave an opening pick at the corner to prevent the adhesive from resealing.
[* icon_caution] The screen's flex cable is located just below the midpoint on the side of the power button, and may interfere with your cutting tool.
[* black] Start to slide the halberd spudger along the lower edge of the phonephone to cut the adhesive. Leave an opening pick at the corner to prevent the adhesive from resealing.
[* icon_caution] The screen's flex cable is located just below the midpoint on the side of the power button, and may interfere with your cutting tool.
[* black] Continue to slide the halberd spudger along the side of the phone and insert another opening pick.
[* icon_note] The screen's flex cable is located just below the midpoint on this side, and may interfere with your cutting tool.