Перейти к основному содержанию

Возврат к шагу #2

Редактировать с помощью Arthur Shi -

Правка одобрена автор Arthur Shi

До
После
Без изменений

Шаг Линий

-[* black] Peel the two foam pieces stuck over both the heatsink and the fan away from the fan.
-[* icon_caution] Don't try to peel the foam directly using your fingers, nails or a flat ended tool. The foam pad is really delicate and you might end up tearing apart the foam.
-[* icon_note] To properly peel the foam pads use a tool with a cone ending like [link|https://eustore.ifixit.com/products/spudger|a spudger] by placing the tip right below the part of the foam that isn't stuck against anything, then lightly press the foam against the tip with your finger and roll the tool all the way to the other end of the foam (see video).
+[* black] Carefully peel the two foam pieces stuck over both the heatsink and the fan away from the fan.
[* icon_note] The foam only needs to be peeled back enough to clear the fan.
+[* icon_caution] The foam is really delicate and tears easily. Use the following technique to peel the foam:
+ [* black] Insert the point of a spudger underneath the part of the foam that isn't stuck against anything,
+ [* black] Press the top of the foam with your finger to hold it in place.
+ [* black] Roll the spudger tip underneath the foam all the way to the other end of the foam to release it.