Перейти к основному содержанию

Возврат к шагу #4

Редактировать с помощью Andrew Optimus Goldheart -

Правка одобрена автор Andrew Optimus Goldheart

До
После
Без изменений

Шаг Линий

-[* black] While still pulling up with the suction cup, insert a wide plastic opening tool into the gap created between the front panel and rear case.
-[* black] Leave the opening tool in the gap and remove the suction cup from the iPad.
-[* black] Unlike in the iPad 2,3, and 4, there is no plastic display bezel on the iPad Mini. Insert the plastic opening tool into the crack between the front panel and the rear case.
+[* black] While holding the glass up with the suction cup, slide the point of an opening pick into the gap between the glass and body of the iPad.
+ [* icon_caution] Don't insert the opening pick any deeper than the black bezel on the side of the display. Inserting the pick too far may damage the LCD.
+[* black] Pull the suction cup's plastic nub to release the vacuum seal and remove the suction cup from the display assembly.

Изображение 1

Старая версия

Новая версия

Изображение 2

Старая версия

Новая версия

Изображение 3

Старая версия

Новая версия