Перейти к основному содержанию

Changes to Step #1

Edit by Sam Goldheart

Правка одобрена автор Sam Goldheart

Удален
Добавлено
Без изменений

Шаг Линий

[* icon_note] The camera bracket is attached to the front panel by adhesive. The use of a heat gunan iOpener to soften the adhesive is highly recommended.
[* black] WithPlace the heat gun setiOpener in the microwave and microwave it for '''one minute''' on "low", begin heating the perimeter aroundhighest power setting.
[* icon_caution] Be careful not to overheat
the camera bracketiOpener during the repair procedure. We recommend waiting at least two minutes before reheating the iOpener.
[* icon_reminder] It is suggested to heatPlace the desired portion in a circular motion pattern to evenly dissipateiOpener over the front facing camera on the front edge of the amounttop of heat throughout the devicedisplay.
[* icon_note] The camera bracket is attached to the front panel by adhesive. The use of a heat gunan iOpener to soften the adhesive is highly recommended.
[* black] WithPlace the heat gun setiOpener in the microwave and microwave it for '''one minute''' on "low", begin heating the perimeter aroundhighest power setting.
[* icon_caution] Be careful not to overheat
the camera bracketiOpener during the repair procedure. We recommend waiting at least two minutes before reheating the iOpener.
[* icon_reminder] It is suggested to heatPlace the desired portion in a circular motion pattern to evenly dissipateiOpener over the front facing camera on the front edge of the amounttop of heat throughout the devicedisplay.

Image 1

Старая версия

Новая версия