Перейти к основному содержанию

Возврат к шагу #25

Редактировать с помощью Jeff Suovanen -

Правка одобрена автор Jeff Suovanen

До
После
Без изменений

Шаг Линий

[* black] Remove the ten screws securing the logic board assembly:
[* red] Two 2.8 mm T3 Torx screws
[* orange] Five 2.9 mm T5 Torx screws
[* yellow] One 3.7 mm T5 Torx screw
[* green] Two 3.8 mm T8 Torx screws
+[* icon_reminder] During reassembly, install these screws only loosely. Adjust the board position if necessary until all the connectors line up, and then tighten the screws.